PayandPack 16 1/2" x 6 1/8" MBP 10801 Replacement BBQ Stainless Review

Customer Ratings:
List Price: $21.43
Sale Price: $6.99
Today's Bonus: 67% Off

As mentioned in another review, the weld holding the screw to the burner is a bit thin. Of the three I ordered, one one broken off out the box; but these fit so tight in the Kirkland grill I didn't worry about it. Works great. I'd order these again...make the grill perform good as new and we've had this one now for well over 5 years.

Click Here For Most Helpful Customer Reviews >>

These burners have a small 3/16 threaded stud at the half circle bend used to attach them to the grill frame. These studs were barely holding on with a tiny welded bead, so I welded them a little more before I install these, because I was afraid the studs would simply break off when I would tighten the nuts on the studs.

Otherwise, burners fit perfectly, look great and appear to be of good quality.

These were for "The Classic" model 720-0021 made by NexGrill and sold by Costo in 2004-2005.

If you do not reinforced these stud welds, do not tighten them strongly, and you should be OK.

Great purchase.

Best Deals for PayandPack 16 1/2" x 6 1/8" MBP 10801 Replacement BBQ Stainless

Just like all the reviews said, the screw was held on by a tiny drop of solder. Mine arrived broken. I didn't bother swapping it out for a new one, because, just by looking at it, the risk of the 2nd one arriving broken was 99%. If it were packed better, this might have scored better. But get ready to flip a coin on whether or not it will arrive in one piece.

Honest reviews on PayandPack 16 1/2" x 6 1/8" MBP 10801 Replacement BBQ Stainless

The burners are exactly the same as the original ones. My old BBQ burners kept getting rust next to the openings for the gas which decreased the heat for cooking. Now with the new burners my BBQ cooks great again.

Find helpful customer reviews and review ratings for PayandPack 16 1/2" x 6 1/8" MBP 10801 Replacement BBQ Stainless

ordered three heat plates and three burners for my kirkland grill.the heat plates were a tight fit but work great.the only problem with the burners is that one of them had the mounting stud broken off and the other two had poor welds. rather than send them back for exchange i took them to a local shop and had them welded.problem solved.cookin critters.